Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

KMD_PM_UNKNOWN_PHASE2_ENTITIES
System Log Message No Phase-2 entities present in tunnel configuration block sa-name
Description Unable to initiate Phase-2 negotiation because of unknown local and remote traffic
selectors in the indicated security association configuration block. For Adaptive Service
PIC, the security association configuratin block refers to the tunnel configured under a
service set with a given rule name and term name.
Type Error: An error occurred
Severity error
Facility LOG_SYSLOG
KMD_PM_UNKNOWN_QM_NOTIFICATION
System Log Message Unknown Quick mode notification notification-name (notification-type) (size lengthubytes)
from remote-address:remote-port for protocol=protocol-idd spi(sizeu)=data
Description The notification message sent by the indicated remote gateway and remote port is not
recognized. Hence Quick Mode notification payload is dropped.
Type Error: An error occurred
Severity error
Facility LOG_SYSLOG
KMD_PM_UNSUPPORTED_KEY
System Log Message Key type = type, not supported
Description The specified key type is unsupported. Public/Private and Pre-shared key are are the
only types supported presently.
Type Error: An error occurred
Severity error
Facility LOG_SYSLOG
KMD_PM_UNSUPPORTED_MODE
System Log Message New group mode not supported currently
Description The IKE New Group mode negotiations failed, because this is not a supported feature
currently.
Type Error: An error occurred
Severity error
Facility LOG_SYSLOG
345Copyright © 2010, Juniper Networks, Inc.
Chapter 43: KMD System Log Messages

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English