Type Event: This message reports an event, not an error
Severity error
Facility LOG_DAEMON
L2CPD_TASK_FORK
System Log Message Unable to fork task-name: error-message
Description The Layer 2 Control Protocol process (l2cpd) could not create the indicated child process.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
L2CPD_TASK_GETWD
System Log Message getwd() failed for error-message
Description The Layer 2 Control Protocol process (l2cpd) invoked the getwd() system call, which
failed.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause It is possible that the kernel lacked the resources needed to fulfill the request. The l2cpd
process continued operating.
L2CPD_TASK_MASTERSHIP
System Log Message Assumed mastership
Description The Layer 2 Control Protocol process (l2cpd) became active when the Routing Engine
on which it was running assumed mastership.
Type Event: This message reports an event, not an error
Severity info
Facility LOG_DAEMON
L2CPD_TASK_NO_REINIT
System Log Message Unable to reinitialize
Description The Layer 2 Control Protocol process (l2cpd) did not reinitialize as requested, because
it was running in a state that did not allow reconfiguration.
Type Error: An error occurred
Severity error
365Copyright © 2010, Juniper Networks, Inc.
Chapter 45: L2CPD System Log Messages
To Next Page
Loading...