Cause The message was logged because task accounting is enabled. The function might be
implemented inefficiently.
L2CPD_RUNTIME_TOTAL
System Log Message function-name: runtime was excessive (total of time in count callbacks) after action of
module
Description After the indicated operation on the indicated submodule of the Layer 2 Control Protocol
process (l2cpd), several functions ran uninterrupted in the indicated number of callbacks
for the indicated period of time, which is considered excessive.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
Cause The message was logged because task accounting is enabled. The function might be
implemented inefficiently.
L2CPD_TASK_BEGIN
System Log Message l2cpd process started (version l2cpd-version built on date by builder)
Description The Layer 2 Control Protocol process (l2cpd) started. It was assigned the indicated
process ID (PID) and was using an executable with the indicated name, version, and build
date.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
L2CPD_TASK_CHILD_KILLED
System Log Message Child process 'task-name' terminated by SIGsignal-name core-dump-status
Description While a child process of the Layer 2 Control Protocol process (l2cpd) was performing
the indicated operation, it terminated in response to the indicated signal.
Type Event: This message reports an event, not an error
Severity error
Facility LOG_DAEMON
L2CPD_TASK_CHILD_STOPPED
System Log Message Child process 'task-name' stopped by SIGsignal-name
Description While a child process of the Layer 2 Control Protocol process (l2cpd) was performing
the indicated operation, it stopped in response to the indicated signal.
Copyright © 2010, Juniper Networks, Inc.364
Junos 10.3 System Log Messages Reference
To Next Page
Loading...