Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Severity error
Facility LOG_AUTH
PPPD_RADIUS_NO_VALID_SERVERS
System Log Message Unable to find valid RADIUS server for profile access-profile
Description The Point-to-Point Protocol process (pppd) could not access a valid RADIUS server to
use for the indicated access profile.
Type Error: An error occurred
Severity error
Facility LOG_AUTH
PPPD_RADIUS_OPEN_FAILED
System Log Message rad_auth_open failed: error-message
Description The Point-to-Point Protocol process (pppd) could not create a RADIUS object handle,
which it uses to communicate with the RADIUS server.
Type Error: An error occurred
Severity error
Facility LOG_AUTH
PPPD_RADIUS_ROUTE_INST_ENOENT
System Log Message Ignored RADIUS server radius-server for profile access-profile because routing instance
routing-instance did not exist
Description The indicated routing instance, which the Point-to-Point Protocol process (pppd) uses
for routing of RADIUS packets, was not defined.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_AUTH
Cause The process of adding the required routing instance was still in progress when the message
was logged.
Action None required. Authentication with the indicated RADIUS server is automatically
reattempted, and can succeed when the interface exists.
485Copyright © 2010, Juniper Networks, Inc.
Chapter 69: PPPD System Log Messages

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English