Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Facility ANY
Action Modify the configuration statement to use a valid value.
RPD_BGP_CFG_LOCAL_ASNUM_WARN
System Log Message local as-number cannot be set to confederation as-number data-id, statement ignored
Description Local autonomous-system number cannot be set to the confederation
autonomous-system number. Statement will be ignored.
Type Event: This message reports an event, not an error
Severity warning
Facility ANY
RPD_BGP_NEIGHBOR_STATE_CHANGED
System Log Message BGP peer peer-name changed state from old-state to new-state (event event-type)
Description During BGP negotiation with the local router, the state of the indicated BGP neighbor
(peer) changed as indicated. The ESTABLISHED state is the final state in the neighbor
negotiation.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
RPD_CFG_TRACE_FILE_MISSING
System Log Message No file specified under traceoptions hierarchy
Description The routing protocol process (rpd) could not find the 'file' statement under a traceoptions
hierarchy. This would prevent it from performing tracing.
Type Event: This message reports an event, not an error
Severity warning
Facility ANY
RPD_DYN_CFG_BUSY_SIGNAL_FAILED
System Log Message Dynamic config action busy signal failed: error-message
Description The routing protocol process (rpd) failed to notify the dynamic configuration clients
about its availability to process the dynamic configuration requests.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
Copyright © 2010, Juniper Networks, Inc.502
Junos 10.3 System Log Messages Reference

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English