instance of rpd that was using the indicated binary and had the indicated process ID
(PID) continued running. The process created a diagnostic core dump for analysis by
technical support personnel.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Cause An internal software failure occurred.
Action Examine the messages that immediately follow this message in the system log for
information about possible causes. Contact a technical support representative, and be
ready to provide the list of messages and the diagnostic core dump, if requested.
RPD_BFD_READ_ERROR
System Log Message Read error on pipe from bfdd: reason (error-message)
Description The routing protocol process (rpd) could not read a message available on the read pipe
from the Bidirectional Forwarding Detection process (bfdd).
Type Error: An error occurred
Severity info
Facility LOG_DAEMON
Action Contact your technical support representative.
RPD_BFD_WRITE_ERROR
System Log Message function-name: write error on pipe to bfdd (error-message)
Description The routing protocol process (rpd) could not write a message on the pipe to the
Bidirectional Forwarding Detection process (bfdd).
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
RPD_BGP_CFG_ADDR_INVALID
System Log Message Invalid argument address ip-address
Description An invalid local or neighbor address was encountered while parsing BGP configuration.
Type Event: This message reports an event, not an error
Severity warning
501Copyright © 2010, Juniper Networks, Inc.
Chapter 73: RPD System Log Messages
To Next Page
Loading...