Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Type Event: This message reports an event, not an error
Severity info
Facility LOG_DAEMON
RPD_ISIS_ADJUPNOIP
System Log Message IS-IS new Lisis-level adjacency to neighbor-system-ids on interface-name without an
address
Description An IS-IS adjacency was established with the indicated neighboring router, which is not
configured for IS-IS for IP.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
Cause The neighboring router is misconfigured: it is enabled for IS-IS but not for exchange of IP
route information.
Action Configure the neighboring router for IS-IS with IP, or remove it from the IS-IS mesh.
RPD_ISIS_LDP_SYNC
System Log Message IS-IS interface interface-name advertised with infinite metric for duration seconds already
due to loss of synchronization with LDP
Description The IS-IS protocol lost synchronization with the Label Distribution Protocol (LDP) on the
indicated interface. As a consequence, it began advertising an infinite metric for the
interface and has been doing so for the indicated number of seconds.
Type Error: An error occurred
Severity warning
Facility LOG_DAEMON
Action Determine why LDP lost synchronization with IS-IS.
RPD_ISIS_LSPCKSUM
System Log Message IS-IS Lisis-level LSP checksum error, interface interface-name, LSP id lspl, sequence
sequence-number, checksum checksum, lifetime duration
Description The indicated IS-IS informational link-state PDU (LSP) failed an internal checksum
validity test, implying that it was corrupted.
Type Error: An error occurred
Severity warning
Facility LOG_DAEMON
513Copyright © 2010, Juniper Networks, Inc.
Chapter 73: RPD System Log Messages

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English