Cause The packet was corrupted in transit between the neighboring IS-IS router and this router,
or memory on one of the routers was corrupted.
Action None, unless a large number of these messages appear in the system log file. The
corrupted LSP is silently discarded.
RPD_ISIS_NO_ROUTERID
System Log Message IS-IS instance does not have a valid router ID
Description The IS-IS instance did not have a valid router ID.
Type Error: An error occurred
Severity alert
Facility LOG_DAEMON
Cause When a router ID is not explicitly configured for an instance, IPv4 addresses configured
under the instance are considered in the selection of the router ID. In this case, the instance
did not have a router ID configured and no IPv4 addresses were configured.
Action Either configure a router ID by including the 'routing-instance' statement under the
instance, or configure an IPv4 address by including the 'family inet' statement under one
of the interfaces of the instance. You can also configure both.
RPD_ISIS_OVERLOAD
System Log Message IS-IS database overload
Description The IS-IS link-state database is full and no additional memory can be allocated for it.
Type Error: An error occurred
Severity alert
Facility LOG_DAEMON
Cause No additional memory is available for storing IS-IS link-state information. Either system
resources are exhausted or a software error occurred (such as a memory leak in the
routing protocol process [rpd]). In the former case, IS-IS might be carrying too much
information, or the router configuration includes too many features that use large amounts
of system memory.
Action Perform one or more of the following actions: (1) Check for unusually high memory usage
by the IS-IS task or rpd, (2) Unconfigure features that use large amounts of memory, (3)
Add more memory to the Routing Engine, (4) Carry fewer IS-IS routes.
RPD_KRT_CCC_IFL_MODIFY
System Log Message error-code, error-message
Copyright © 2010, Juniper Networks, Inc.514
Junos 10.3 System Log Messages Reference
To Next Page
Loading...
Need help?
General
