Description The routing protocol process (rpd) received a message from the kernel that specified
the cell-relay encapsulation for the indicated physical interface, but not the cell-relay
mode.
Type Error: An error occurred
Severity notice
Facility LOG_DAEMON
RPD_KRT_IFD_GENERATION
System Log Message ifd interface-device-index generation mismatch -- rpd rpd-generation kernel
kernel-generation
Description The routing protocol process (rpd) received a message from the kernel in which the
physical interface associated with the indicated numerical index differed from the
interface-to-index mapping maintained by rpd.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
Cause It is possible that rpd discarded some interface messages from the kernel without
processing them because it received more messages than it could handle. It will recover.
RPD_KRT_IFL_CELL_RELAY_INV_MODE
System Log Message Invalid mode (mode) specified for logical interface interface-name; defaulting to port
mode
Description The routing protocol process (rpd) received a message from the kernel that specified
the cell-relay encapsulation for the indicated logical interface, but the specified cell-relay
mode (port, virtual-circuit, or virtual-path) was invalid.
Type Error: An error occurred
Severity notice
Facility LOG_DAEMON
RPD_KRT_IFL_CELL_RELAY_NO_MODE
System Log Message No mode specified for logical interface interface-name; defaulting to port mode
Description The routing protocol process (rpd) received a message from the kernel that specified
the cell-relay encapsulation for the indicated logical interface but not the cell-relay mode.
Type Error: An error occurred
Severity notice
Facility LOG_DAEMON
517Copyright © 2010, Juniper Networks, Inc.
Chapter 73: RPD System Log Messages
To Next Page
Loading...