RPD_MC_DESIGNATED_PE_CHANGE
System Log Message Designated forwarder changed to ip-address for backup-pe-group group-name in
routing-instance instance
Description The routing protocol daemon (rpd) assigned the indicated Provider Edge (PE) as the
new designated forwarder of the indicated routing instance for the indicated
backup-pe-group.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
RPD_MC_DYN_CFG_ALREADY_BOUND
System Log Message Dynamic configuration session id client-session-id for interface interface-name is already
bound to interface old-interface-name.
Description The dynamic configuration instantiation request was rejected because the specified
dynamic configuration sesssion ID was already bound to another interface.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Unbind the session ID from the existing interface.
RPD_MC_DYN_CFG_SES_ID_ADD_FAIL
System Log Message Failed to add dynamic configuration session id client-session-id to interface
interface-name.
Description The dynamic configuration instantiation request was rejected because the routing protocol
process failed to associate the specified dynamic configuration session ID with the
specified interface.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
RPD_MC_DYN_CFG_SES_ID_MISMATCH
System Log Message Dynamic configuration entry for interface interface-name with session id client-session-id
found an existing entry with a different session id of client-session-id-1.
Description The dynamic configuration instantiation request was rejected because the request
matched an existing dynamic configuration block that had a different session ID.
531Copyright © 2010, Juniper Networks, Inc.
Chapter 73: RPD System Log Messages
To Next Page
Loading...