Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
RPD_RA_DYN_CFG_SES_ID_MISMATCH
System Log Message Dynamic configuration entry for interface interface-name with session id client-session-id
found an existing entry with a different session id of client-session-id-1.
Description The dynamic configuration instantiation request was rejected because it matched an
existing dynamic configuration block that had a different session ID.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
RPD_RDISC_CKSUM
System Log Message Bad checksum for router solicitation from source-address to destination-address
Description The routing protocol process (rpd) ignored a router discovery solicitation message from
the indicated address because the checksum in the message's ICMP header was invalid.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
Cause The solicitation message was incorrectly generated or damaged in transit.
Action Examine the host that generated the solicitation message.
RPD_RDISC_NOMULTI
System Log Message Ignoring interface interface-address on interface-name -- multicast not available
Description The indicated interface was configured for router discovery, but does not support IP
multicast operations as required. The routing protocol process (rpd) did not enable router
discovery on the interface.
Type Error: An error occurred
Severity warning
Facility LOG_DAEMON
Action Do not configure router discovery on the interface.
Copyright © 2010, Juniper Networks, Inc.552
Junos 10.3 System Log Messages Reference

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English