RPD_RDISC_NORECVIF
System Log Message Unable to locate interface for router solicitation from source-address to
destination-address
Description The routing protocol process (rpd) ignored a router discovery solicitation message from
the indicated router because the router's IP address does not share the IP prefix of the
local router. The local router is not a candidate for the indicated router because they are
not on the same network.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
Cause Although the indicated router seems to be locally attached, no interfaces on the local
router are configured to handle its IP address. Either the indicated router is configured
with the wrong IP address, or the local router is not correctly configured for the network
that the indicated router is using.
Action Ignore this message if it indicates the desired configuration, or reconfigure one or both
routers to share a common network.
RPD_RDISC_SOLICITADDR
System Log Message Expected multicast (expected-address) for router solicitation from source-address to
destination-address
Description A router discovery solicitation message received from the indicated address was not sent
to the expected multicast address for all routers.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
Action Examine the configuration of the router that generated the router discovery solicitation
message.
RPD_RDISC_SOLICITICMP
System Log Message Nonzero ICMP code (value) for router solicitation from source-address to
destination-address
Description The routing protocol process (rpd) ignored a router discovery solicitation message from
the indicated router because the ICMP code in the message header was nonzero.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
553Copyright © 2010, Juniper Networks, Inc.
Chapter 73: RPD System Log Messages
To Next Page
Loading...
Need help?
General
