Description The indicated total number of prefixes in the indicated routing table equaled or exceeded
the indicated configured limit. Attempts to add some types of prefix to the table fail while
this condition holds, but the prefix count can exceed the limit if prefixes are forcibly added
(for example, for static routes). This message first appears in the log when the limit is
reached and repeats periodically until the number of prefixes goes below the limit.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
RPD_RT_PREFIX_LIMIT_WARNING
System Log Message Number of prefixes (prefix-count) in table table-name reached warning threshold
(threshold percent of configured maximum limit)
Description The indicated total number of prefixes in the indicated routing table reached the threshold
for a warning. The threshold is the indicated percentage of the indicated configured limit
on the number of prefixes.
Type Event: This message reports an event, not an error
Severity warning
Facility LOG_DAEMON
RPD_RT_SHOWMODE
System Log Message invalid display mode (mode)
Description The indicated display mode was specified in a 'show route' command and is unsupported.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
RPD_RT_TAG_ID_ALLOC_FAILED
System Log Message Unable to allocate object-name for routing instance instance
Description The routing protocol process (rpd) could not allocate either labels or subunits (as
indicated) for the indicated routing instance, because the result number of objects would
have exceeded the limit.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
RPD_SCHED_CALLBACK_LONGRUNTIME
System Log Message function-name: excessive runtime time during action of module
561Copyright © 2010, Juniper Networks, Inc.
Chapter 73: RPD System Log Messages
To Next Page
Loading...
Need help?
General
