Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Facility LOG_DAEMON
Cause The duration was noted because task accounting is enabled. The function might be
implemented inefficiently.
RPD_SIGNAL_TERMINATE
System Log Message signal-name termination signal received
Description In response to the indicated termination request, the routing protocol process (rpd)
terminated adjacencies with neighbors and shut down.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_DAEMON
RPD_SNMP_CONN_PROG
System Log Message function-name: error-message
Description The indicated error occurred while the routing protocol process (rpd) was connecting to
the Simple Network Management Protocol (SNMP) master agent.
Type Error: An error occurred
Severity info
Facility LOG_DAEMON
RPD_SNMP_CONN_QUIT
System Log Message function-name: unable to connect to SNMP agent (pathname): error-message
Description The routing protocol process (rpd) could not connect to the indicated Simple Network
Management Protocol (SNMP) master agent.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
RPD_SNMP_CONN_RETRY
System Log Message function-name: reattempting connection to SNMP agent (pathname): error-message
Description The routing protocol process (rpd) tried again to connect to the indicated Simple Network
Management Protocol (SNMP) master agent after a connection attempt failed.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
563Copyright © 2010, Juniper Networks, Inc.
Chapter 73: RPD System Log Messages

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English