Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

UI_CHILD_STOPPED
System Log Message Child stopped: PID pid, signal=signal-namecore-dump-status, command='command')
Description The management process (mgd) created a child process to execute the indicated
command for it. The child process received the indicated signal and stopped.
Type Error: An error occurred
Severity notice
Facility ANY
Cause An internal software failure occurred.
Action Contact your technical support representative.
UI_CHILD_WAITPID
System Log Message waitpid failed: PID pid, rc return-value, status status-code: error-message
Description The management process (mgd) created a child process to execute a command for it.
It could not wait for the child process to finish.
Type Error: An error occurred
Severity error
Facility ANY
Cause An internal software failure occurred.
Action Contact your technical support representative.
UI_CMDLINE_READ_LINE
System Log Message User 'username', command 'command'
Description The indicated user typed the indicated command at the CLI prompt and pressed the
Enter key, sending the command string to the management process (mgd).
Type Event: This message reports an event, not an error
Severity info
Facility LOG_AUTH
UI_CMD_AUTH_REGEX_INVALID
System Log Message Invalid 'allow-deny' command authorization regular expression 'regular-expression':
error-message
Description An operation that attempted to set command or configuration authorization included
the indicated regular expression. The operation failed because the expression syntax
was invalid.
637Copyright © 2010, Juniper Networks, Inc.
Chapter 88: UI System Log Messages

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English