Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

UI_DBASE_ACCESS_FAILED
System Log Message Unable to reaccess configuration database file 'filename', address address, size size:
reason
Description To increase the size of the configuration database, the management process (mgd)
must unmap the database from its address space, change the database size, and remap
the database. The remapping operation failed.
Type Error: An error occurred
Severity error
Facility ANY
Cause An internal software failure occurred.
Action Contact your technical support representative.
UI_DBASE_CHECKOUT_FAILED
System Log Message Database 'filename' is out of data and needs to be rebuilt
Description When the routing platform boots, the management process (mgd) checks the
configuration database for internal consistency. It found one or more inconsistencies.
Type Event: This message reports an event, not an error
Severity alert
Facility ANY
Cause mgd restarted after new JUNOS software was installed.
Action None; mgd will rebuild the database.
UI_DBASE_EXTEND_FAILED
System Log Message Unable to extend configuration database file 'filename' to size requested-size: reason
Description The management process (mgd) could not increase the configuration database to the
indicated size.
Type Error: An error occurred
Severity error
Facility ANY
Cause The hard disk is defective or is not installed in the routing platform.
Action Repair or replace the hard disk.
643Copyright © 2010, Juniper Networks, Inc.
Chapter 88: UI System Log Messages

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English