CHAPTER 13
Maintaining the Junos Pulse Gateway
Hardware Components
•
Maintaining the Junos Pulse Gateway Hardware Components on page 97
Maintaining the Junos Pulse Gateway Hardware Components
Table 26 on page 97 describes the common tasks for maintaining the hardware
components of the Junos Pulse Gateway.
Table 26: Maintenance Procedures for the Junos Pulse Gateway Hardware
Components
Procedure
Maintenance
Procedure
To maintain optimum performance of the Junos Pulse Gateway, you
should regularly perform the following preventive maintenance procedures:
•
Inspect the installation site for moisture, loose wires or cables, and
excessive dust.
•
Make sure that the airflow is unobstructed around the device and into
the air intake vents.
•
Check the Status LED on the front panel of the MAG2600 or the service
module on all other Junos Pulse Gateway models.
Routine
maintenance
procedures
The Junos Pulse Gateway cooling system works to maintain an optimal
temperature for the device. If the fan controller fails, the device
temperature will exceed the maximum working temperature, and the
device will fail. Make sure that you maintain the recommended clearances
behind the device to enable the cooling system to function optimally.
Maintaining the
cooling system
To maintain the power supply on the Junos Pulse Gateway:
•
Make sure that the power and grounding cables are arranged so that
they do not obstruct access to other device components.
•
Periodically inspect the site to ensure that the grounding and power
cables connected to the device are securely in place and that there is
no moisture accumulating near the device.
CAUTION: We recommend using a surge protector for the power
connection.
Maintaining the
power supply
97Copyright © 2014, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
