Figure 20: Securing the MAG-RK1U Front Rail
7. Slide the rear rail onto the front rail. The ear of the rear rail should be facing the rear
of the Junos Pulse Gateway chassis and pointing outward.
Figure 21: Sliding the MAG-RK1U Rear Rails In Place
8. Measure your rack or cabinet to determine the distance between the ear on the front
rail and the ear on the back rail and adjust your rear rail accordingly.
9. Secure the rear rail to the front rail using the flat-head M4 screws.
Copyright © 2014, Juniper Networks, Inc.56
Junos
®
Pulse Gateway Hardware Guide
To Next Page
Loading...
Need help?
General
