Table 18: Site Preparation Checklist for the Junos Pulse Gateway
Installation (continued)
Date and NotesAdditional InformationItem or Task
•
Verify that the area
selected meets the
minimum requirements
•
Plan the installation
location, including required
space clearances and
airflow requirements.
Cables
“Console Port Cable and Wire
Specifications for the Junos
Pulse Gateway” on page 120
•
Acquire cables and
connectors.
•
Review the maximum
distance allowed for each
cable. Choose the length of
cable based on the distance
between the hardware
components being
connected.
•
Plan the cable routing and
management.
Related
Documentation
General Site Guidelines for Installing the Junos Pulse Gateway on page 28•
• Junos Pulse Gateway Electrical and Power Requirements on page 29
• Junos Pulse Gateway Rack Requirements on page 31
• Junos Pulse Gateway Cabinet Requirements on page 32
• Clearance Requirements for Airflow in and Hardware Maintenance of the Junos Pulse
Gateway on page 33
General Site Guidelines for Installing the Junos Pulse Gateway
The following precautions help you plan an acceptable operating environment for your
Junos Pulse Gateway and avoid environmentally caused equipment failures:
•
For the cooling system to function properly, the airflow around the chassis must be
unrestricted. Allow sufficient clearance between the front and back of the chassis and
adjacent equipment. Ensure that there is adequate circulation in the installation location.
•
Follow the ESD procedures to avoid damaging equipment. Static discharge can cause
components to fail completely or intermittently over time.
•
Ensure that the blank faceplate panel is installed in the empty slot to prevent any
interruption or reduction in the flow of air across the internal components.
Copyright © 2014, Juniper Networks, Inc.28
Junos
®
Pulse Gateway Hardware Guide
To Next Page
Loading...
Need help?
General
