Juniper Junos Pulse MAG2600 - Installing Junos Pulse Gateway Components; Removing and Installing Faceplates; Installing the MAG-SM160 Kit

CHAPTER 8
Installing Junos Pulse Gateway
Components
•
Removing and Installing Faceplates on page 41
•
Installing the MAG-SM160 Kit on page 41
•
Installing the MAG-SM360 Kit on page 43
•
Installing the MAG-SM161 Kit on page 44
•
Installing the MAG-SM361 Kit on page 45
•
Installing an AC Power Supply in the MAG6610 and MAG6611 on page 47
•
Installing a Fan Assembly in the MAG6610 and MAG6611 on page 48
•
Installing a Hard Drive in the MAG6610 or MAG6611 on page 48
•
Installing the Integrated Access Service Modules Overview on page 49
•
Installing a MAG-CM060 Chassis Management Card on page 50
Removing and Installing Faceplates
Faceplates for the MAG6610 and MAG6611 are held in place by tabs. To remove a
faceplate, gently pry the faceplate from the chassis using your fingers or a flat-blade
screw driver. To install a faceplate, line up the faceplate with the open slot and push
gently until it clicks into place.
NOTE: Faceplates are required for proper airflow. If you remove a service
module and do not intend to replace it, cover the opening with a faceplate.
Related
Documentation
Installing the Integrated Access Service Modules Overview on page 49•
• Removing an Integrated Access Service Module on page 93
Installing the MAG-SM160 Kit
The MAG-SM160 kit includes:
•
One MAG-SM160 service module.
41Copyright © 2014, Juniper Networks, Inc.