Juniper MX240 - Unpacking the MX240 Router; Chapter 14 Unpackingthemx240 Router; Tools and Parts Required to Unpack the MX240 Router

CHAPTER 14
Unpacking the MX240 Router
•
Tools and Parts Required to Unpack the MX240 Router on page 163
•
Unpacking the MX240 Router on page 163
•
Verifying the MX240 Router Parts Received on page 165
Tools and Parts Required to Unpack the MX240 Router
To unpack the router and prepare for installation, you need the following tools:
•
Phillips (+) screwdriver, number 2
•
1/2-in. or 13-mm open-end or socket wrench to remove bracket bolts from the shipping
pallet
•
Blank panels to cover any slots not occupied by a component
Related
Documentation
Unpacking the MX240 Router on page 163•
• Verifying the MX240 Router Parts Received on page 165
Unpacking the MX240 Router
The router is shipped in a wooden crate. A wooden pallet forms the base of the crate.
The router chassis is bolted to this pallet. Quick Start installation instructions and a
cardboard accessory box are also included in the shipping crate.
The shipping container measures 21 in. (53.3 cm) high, 23.5 in. (60.0 cm) wide, and
32.5 in. (82.5 cm) deep. The total weight of the container containing the router and
accessories can range from 93 lb (42.2 kg) to 169 lb (76.7 kg).
NOTE: The router is maximally protected inside the shipping crate. Do not
unpack it until you are ready to begin installation.
163Copyright © 2017, Juniper Networks, Inc.