For more information about the command, see the CLI Explorer.
•
To bring a PIC online:
•
Press the PIC offline/online button until the PIC LED lights green. For a PIC installed
in FPC3, use a narrow-ended tool that fits inside the opening that leads to the
button.
•
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the CLI Explorer.
•
To bring a MIC online:
•
Press the MIC offline/online button until the PIC LED lights green.
•
Issue the following CLI command:
user@host>request chassis mic fpc-slot mpc-slot pic-slot mic-slot online
For more information about the command, see the CLI Explorer.
The normal functioning indicator LED confirms that the component is online. You can
also verify correct DPC or MPC functioning by issuing the show chassis fpc command
or correct MIC or PIC functioning by issuing the show chassis fpc pic-status.
Related
Documentation
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444•
• Removing a Cable on an MX240 DPC, MPC, MIC, or PIC on page 320
• Maintaining MX240 DPCs on page 382
• Maintaining MX240 MPCs on page 393
• Maintaining MX240 MICs on page 393
• Maintaining MX240 PICs on page 395
Installing an SFP or XFP Transceiver into an MX240 DPC, MPC, MIC, or PIC
To install an SFP or XFP:
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Take each transceiver to be installed out of its electrostatic bag, and identify the slot
on the component where it will be installed.
3. Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the
transceiver with a safety cap.
255Copyright © 2017, Juniper Networks, Inc.
Chapter 21: Installing Components
To Next Page
Loading...
