Juniper MX240 - Chapter 18 Connecting the MX240 Router to the Network; Tools and Parts Required for MX240 Router Connections; Connecting the MX240 Router to Management and Alarm Devices

CHAPTER 18
Connecting the MX240 Router to the
Network
•
Tools and Parts Required for MX240 Router Connections on page 211
•
Connecting the MX240 Router to Management and Alarm Devices on page 211
•
Connecting theMX240 Router to a Network for Out-of-Band Management on page 214
•
Connecting the MX240 Router to a Management Console or Auxiliary Device on page 215
•
Connecting the MX240 Router to an External Alarm-Reporting Device on page 216
•
Connecting DPC, MPC, MIC, or PIC Cables to the MX240 Router on page 217
Tools and Parts Required for MX240 Router Connections
To connect the router to management devices and line cards, you need the following
tools and parts:
•
Phillips (+) screwdrivers, numbers 1 and 2
•
2.5-mm flat-blade (–) screwdriver
•
2.5-mm Phillips (+) screwdriver
•
Wire cutters
•
Electrostatic discharge (ESD) grounding wrist strap
Related
Documentation
Connecting the MX240 Router to Management and Alarm Devices on page 211•
• Connecting DPC, MPC, MIC, or PIC Cables to the MX240 Router on page 217
Connecting the MX240 Router to Management and Alarm Devices
•
Connecting the MX240 Routerto a Network for Out-of-Band Managementon page 212
•
Connecting the MX240 Router to a Management Console or Auxiliary Device on page 212
•
Connecting the MX240 Router to an External Alarm-Reporting Device on page 213
211Copyright © 2017, Juniper Networks, Inc.