Juniper MX240 - Chapter 34 Generalsafetyguidelinesandwarnings; General Safety Guidelines and Warnings

CHAPTER 34
General Safety Guidelines and Warnings
•
General Safety Guidelines and Warnings on page 439
•
Definitions of Safety Warning Levels on page 440
•
Qualified Personnel Warning on page 442
•
Fire Safety Requirements on page 443
•
Warning Statement for Norway and Sweden on page 444
•
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
General Safety Guidelines and Warnings
The following guidelines help ensure your safety and protect the device from damage.
The list of guidelines might not address all potentially hazardous situations in your working
environment, so be alert and exercise good judgment at all times.
•
Perform only the procedures explicitly described in the hardware documentation for
this device. Make sure that only authorized service personnel perform other system
services.
•
Keep the area around the device clear and free from dust before, during, and after
installation.
•
Keep tools away from areas where people could trip over them while walking.
•
Do not wear loose clothing or jewelry, such as rings, bracelets, or chains, which could
become caught in the device.
•
Wear safety glasses if you are working under any conditions that could be hazardous
to your eyes.
•
Do not perform any actions that create a potential hazard to people or make the
equipment unsafe.
•
Never attempt to lift an object that is too heavy for one person to handle.
•
Never install or manipulate wiring during electrical storms.
•
Never install electrical jacks in wet locations unless the jacks are specifically designed
for wet environments.
•
Operate the device only when it is properly grounded.
439Copyright © 2017, Juniper Networks, Inc.