Figure 149: Removing an AS MXC
Installing an MX240 AS MXC
To install an AS MXC (see Figure 103 on page 253):
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Align the notches in the connector at the rear of the AS MXC with the notches in the
AS MXC slot (slot 1—the bottom slot in the AS MLC), and then slide the AS MXC in
until it lodges firmly in the AS MLC.
CAUTION: Slide the AS MXC straight into the slot to avoid damaging the
components on the bottom of the AS MXC.
3. Use one of the following methods to bring the AS MXC online:
•
Press the AS MXC offline/online button until the LED light turns green.
•
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
333Copyright © 2017, Juniper Networks, Inc.
Chapter 25: Replacing Line Card Components
To Next Page
Loading...
