Juniper MX240 - Figure 86: Attaching a Cable to a DPC; Figure 87: Attaching a Cable to a MIC

CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius.An arcsmaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
Figure 86: Attaching a Cable to a DPC
Fiber-optic cable
connector
Figure 87: Attaching a Cable to a MIC
g004928
Fiber-optic cable
Related
Documentation
• Connecting the MX240 Router to Management and Alarm Devices on page 211
• Installing an MX240 DPC on page 233
• Installing an MX240 PIC on page 247
• Installing an MX240 MPC on page 243
• Installing an MX240 MIC on page 240
Copyright © 2017, Juniper Networks, Inc.218
MX240 3D Universal Edge Router Hardware Guide