EasyManua.ls Logo

Juniper MX240 - Holding an MX240 FPC

Juniper MX240
512 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
State Online
Temperature 37 degrees C / 98 degrees F
Total CPU DRAM 1024 MB
Total RLDRAM 128 MB
Total DDR DRAM 2048 MB
Start time: 2008-11-25 11:16:43 PST
Uptime: 25 minutes, 26 seconds
Issue the CLI show chassis fpc pic-status command. The following example shows an
FPC installed in DPC slots 1 and 2:
user@host> show chassis fpc pic-status
Slot 0 Online DPC 40x 1GE R
PIC 0 Online 10x 1GE(LAN)
PIC 1 Online 10x 1GE(LAN)
PIC 2 Online 10x 1GE(LAN)
PIC 3 Online 10x 1GE(LAN)
Slot 1 Online MX FPC Type 3
PIC 0 Online 1x OC-192 SONET
PIC 1 Online 1x OC-192 SONET
NOTE: An FPC takes up two DPC slots when installed on an MX Series
router. The slot number corresponds to the lowest numbered DPC slot.
For further description of the output from the command, see the CLI Explorer.
Related
Documentation
MX240 Flexible PIC Concentrator (FPC) LEDs on page 59
Holding an MX240 FPC on page 388
Storing an MX240 FPC on page 392
Troubleshooting the MX240 FPCs on page 406
Replacing an MX240 FPC on page 302
Holding an MX240 FPC
CAUTION: Many components on the FPC are fragile. Failure to handle FPCs
as specified in this document can cause irreparable damage.
NOTE: An FPC configured with PICs installed can weigh as much as
18 lb (8.2 kg). Be prepared to accept the full weight of the FPC as you lift it.
To prevent damage when handling or carrying FPCs:
Copyright © 2017, Juniper Networks, Inc.388
MX240 3D Universal Edge Router Hardware Guide

Table of Contents

Other manuals for Juniper MX240

Related product manuals