Figure 82: Routing Engine Ethernet Cable Connector
Related
Documentation
Tools and Parts Required for MX240 Router Connections on page 211•
• Connecting DPC, MPC, MIC, or PIC Cables to the MX240 Router on page 217
Connecting the MX240 Router to a Management Console or Auxiliary Device
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate CONSOLE port on the Routing Engine. To use a laptop, modem, or other
auxiliary device, connect it to the AUX port on the Routing Engine. Both ports accept a
cable with an RJ-45 connector. One serial cable with an RJ-45 connector and a DB-9
connector is provided with the router. To connect a device to the CONSOLE port and
another device to the AUX port, you must supply an additional cable.
To connect a management console or auxiliary device:
1. Turn off the power to the console or auxiliary device.
2. Plug the RJ-45 end of the serial cable (Figure 79 on page 213 shows the connector)
intothe AUX port or CONSOLE port on the RoutingEngine.Figure78 on page 213 shows
the ports.
3. Plug the female DB-9 end into the device's serial port.
NOTE:
For console devices, configure the serial port to the following values:
•
Baud rate—9600
•
Parity—N
•
Data bits—8
•
Stop bits—1
•
Flow control—none
215Copyright © 2017, Juniper Networks, Inc.
Chapter 18: Connecting the MX240 Router to the Network
To Next Page
Loading...
