Juniper MX240 - Figure 105: Installing a DC Power Supply in the Router; Figure 106: Connecting DC Power to the Router

NOTE: If more than one power supply is being installed, turn on all power
supplies at the same time.
NOTE: An SCB must be present for the PWR OK LED to go on.
Figure 105: Installing a DC Power Supply in the Router
Figure 106: Connecting DC Power to the Router
Related
Documentation
MX240 DC Power Supply Description on page 92•
• Removing an MX240 DC Normal-Capacity Power Supply on page 339
• Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
• DC Power Wiring Sequence Warning for M Series, MX Series, and T Series Routers
Copyright © 2017, Juniper Networks, Inc.260
MX240 3D Universal Edge Router Hardware Guide