3. Rotate the ejector handles simultaneously counterclockwise to unseat the SCB.
4. Grasp the ejector handles, and slide the SCB about halfway out of the chassis.
5. Place one hand underneath the SCB to support it, and slide it completely out of the
chassis. Place it on the antistatic mat.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
6. Repeat the procedure for each SCB.
Figure 64: Removing an SCB
Removing the DPCs Before Installing the MX240 Router without a Lift
To remove a DPC (see Figure 65 on page 187):
1. Have ready an antistatic mat for the DPC. Also have ready rubber safety caps for each
DPC using an optical interface on the DPC that you are removing.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to an approved site ESD grounding point. See the instructions for your site.
3. Simultaneously turn both the ejector handles counterclockwise to unseat the DPC.
Copyright © 2017, Juniper Networks, Inc.186
MX240 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
