SSD 1. The spare SSD is Juniper part number SSD-32G-RE-S. Figure 118 on page 279 shows
the arrangement of storage drive slots on a RE-S-1800 Routing Engine.
Figure 118: RE-S-1800 Storage Drive Slots
USB
port
Status LEDs
SSD
slot 2
SSD
slot 1
Online/Offline
button
Extractor
clip
Extractor
clip
g006039
Console
port
Auxiliary
port
Ethernet
port
The following drive has been verified to work in the RE-S-1800 Routing Engine:
•
SSD-32G-RE-S
To replace a storage drive:
1. Disable and deactivate the storage drive.
2. Remove the storage drive.
a. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to an ESD point on the appliance.
For more information about ESD, see Preventing Electrostatic Discharge Damage
in the hardware guide for your router.
b. Unfasten the thumbscrew that secures the access door in front of the storage drive
slots, and open the door.
c. Slide the lock on the ejector to the unlocked position.
d. Carefully slide the drive out of the slot.
3. Reinstall a storage drive.
a. Carefully align the sides of the drive with the guides in the slot.
b. Slide the drive into the slot until you feel resistance, carefully ensuring that it is
correctly aligned.
c. Close the access door and tighten the thumbscrew to secure the door.
Related
Documentation
Returning a Hardware Component to Juniper Networks, Inc. on page 432•
279Copyright © 2017, Juniper Networks, Inc.
Chapter 24: Replacing Host Subsystem Components
To Next Page
Loading...
