Figure 57: Reinstalling a Power Supply
Reinstalling the Fan Tray After Installing the MX240 Router with a Lift
To reinstall the fan tray (see Figure 58 on page 180):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
2. Grasp the fan tray on each side and insert it straight into the chassis. Note the correct
orientation by the "this side up" label on the top surface of the fan tray.
3. Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
Figure 58: Reinstalling a Fan Tray
Copyright © 2017, Juniper Networks, Inc.180
MX240 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
