Juniper MX240 - Installing the MX240 Air Filter; Figure 112: Removing the Air Filter; Figure 113: Installing the Air Filter

Figure 112: Removing the Air Filter
Installing the MX240 Air Filter
To install the air filter (see Figure 89 on page 231):
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Locate the up arrow and ensure that the air filter is right side up.
3. Slide the air filter straight into the chassis until it stops.
4. Align the captive screws of the air filter cover with the mounting holes on the chassis.
5. Tighten the captive screws on the air filter cover.
Figure 113: Installing the Air Filter
Copyright © 2017, Juniper Networks, Inc.270
MX240 3D Universal Edge Router Hardware Guide