Juniper MX240 - Storing an MX240 DPC; Figure 160: Do Not Rest the DPC on an Edge

Figure 160: Do Not Rest the DPC on an Edge
If you must rest the DPC temporarily on an edge while changing its orientation between
vertical and horizontal, use your hand as a cushion between the edge and the surface.
Related
Documentation
Maintaining MX240 DPCs on page 382•
• MX240 DPC Terminology
• Storing an MX240 DPC on page 386
• Troubleshooting the MX240 DPCs on page 404
• Replacing an MX240 DPC on page 297
Storing an MX240 DPC
You must store a DPC as follows:
•
In the router
•
In the container in which a spare DPC is shipped
•
Horizontally and sheet metal side down
When you store a DPC on a horizontal surface or in the shipping container, always place
it inside an antistatic bag. Because the DPC is heavy, and because antistatic bags are
fragile, inserting the DPC into the bag is easier with two people. To do this, one person
holds the DPC in the horizontal position with the faceplate facing the body, and the other
person slides the opening of the bag over the DPC connector edge.
Copyright © 2017, Juniper Networks, Inc.386
MX240 3D Universal Edge Router Hardware Guide