3. Remove the SSD.
a. Attach an ESD grounding strap to your bare wrist, and connect the strap to an ESD
point on the appliance.
For more information about ESD, see Preventing Electrostatic Discharge Damage
in the hardware guide for your router.
b. Unfasten the thumbscrew that secures the access door in front of the storage drive
slots, and open the door.
c. Slide the lock on the ejector to the unlocked position.
d. Carefully slide the drive out of the slot.
Figure 120: Removing an SSD in the Routing Engine RE-S-X6-64G
4. Reinstall an SSD:
a. Carefully align the sides of the drive with the guides in the slot.
b. Slide the drive into the slot until you feel resistance, carefully ensuring that it is
correctly aligned.
c. Close the access door and tighten the thumbscrew to secure the door.
Copyright © 2017, Juniper Networks, Inc.282
MX240 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
