You hold an FPC horizontally when installing it into the chassis or an equipment rack. To
hold an FPC vertically (see Figure 164 on page 391):
1. Orient the FPC so that the faceplate faces you.
2. Place one hand around the FPC faceplate about a quarter of the way down from the
top edge. To avoid deforming the electromagnetic interference (EMI) shielding strip,
do not press hard on it.
3. Place your other hand at the bottom edge of the FPC. If the FPC has heat sinks about
midway between the faceplate and connector edge, place your other hand against
the heat sinks.
Figure 164: Holding an FPC Vertically
Related
Documentation
MX240 FPC Terminology•
• Storing an MX240 FPC on page 392
• Replacing an MX240 FPC on page 302
• Tools and Parts Required to Replace MX240 Hardware Components on page 226
391Copyright © 2017, Juniper Networks, Inc.
Chapter 29: Maintaining Components
To Next Page
Loading...
