• Protocols and Applications Supported by the Multiservices DPC (MS-DPC)
Interface Modules—FPCs and PICs
•
MX240 Flexible PIC Concentrator (FPC) Description on page 57
•
MX240 Flexible PIC Concentrator (FPC) LEDs on page 59
•
FPCs Supported by MX240, MX480, and MX960 Routers on page 59
•
MX240 PIC Description on page 59
•
MX240 PIC Port and Interface Numbering on page 60
•
MX240 PIC LEDs on page 61
•
PICs Supported by MX240, MX480, and MX960 Routers on page 62
MX240 Flexible PIC Concentrator (FPC) Description
A Flexible PIC Concentrator (FPC) occupies two DPC slots on an MX Series router. The
DPC slots are numbered 1/0, 1,and 2, bottomtotop. One FPC can be installed horizontally
in either slots 1/0 and 1, or slots 1 and 2 on the front of the router (see Figure 24 on page 58).
The interface corresponds to the lowest numbered DPC slot for which the FPC is installed.
Figure 23 on page 57 shows typical FPCs supported on the MX240 router.
Figure 23: Typical FPCs Supported on the MX240 Router
g004417
DPCE-X-Q-40GE
DPCE-X-Q-40GE
FPC3MX-FPC2
MX-FPC2
If a slot is not occupied by a DPC, an FPC, or an SCB, a blank panel must be installed to
shield the empty slot and to allow cooling air to circulate properly through the router.
57Copyright © 2017, Juniper Networks, Inc.
Chapter 6: Line Card Components and Descriptions
To Next Page
Loading...
