Juniper MX240 - Powering on an AC-Powered MX240 Router; Figure 73: Connecting AC Power to the Routers

Figure 73: Connecting AC Power to the Routers
Related
Documentation
Connecting an MX240 AC Power Supply Cord on page 206•
• Disconnecting an MX240 AC Power Supply Cord on page 338
• Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
• AC Power Cord Specifications for the MX240 Router on page 140
Powering On an AC-Powered MX240 Router
To power on an AC-powered router:
1. Verify that the power supplies are fully inserted in the chassis.
2. Verify that each AC power cord is securely inserted into its appliance inlet.
3. Verify that an external management device is connected to one of the Routing Engine
ports (AUX, CONSOLE, or ETHERNET).
4. Turn on the power to the external management device.
5. Switch on the dedicated customer site circuit breakers for the power supplies. Follow
the instructions for your site.
6. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
7. Switch the AC input switch on each power supply to the on (|) position and observe
the status LEDs on each power supply faceplate. If an AC power supply is correctly
Copyright © 2017, Juniper Networks, Inc.200
MX240 3D Universal Edge Router Hardware Guide