Juniper MX240 - Chapter 21 Installing Components; Installing the MX240 Craft Interface

CHAPTER 21
Installing Components
•
Installing the MX240 Craft Interface on page 229
•
Installing the MX240 Air Filter on page 230
•
Installing the MX240 Normal-Capacity Fan Tray on page 231
•
Installing an MX240 Routing Engine on page 232
•
Installing an MX240 DPC on page 233
•
Installing an MX240 FPC on page 238
•
Installing an MX240 MIC on page 240
•
Installing an MX240 MPC on page 243
•
Installing an MX240 Dual-Wide MIC on page 245
•
Installing an MX240 PIC on page 247
•
Installing an MX240 AS MLC on page 249
•
Installing an MX240 AS MSC on page 251
•
Installing an MX240 AS MXC on page 252
•
Installing a Cable on an MX240 DPC, MPC, MIC, or PIC on page 254
•
Installing an SFP or XFP Transceiver into an MX240 DPC, MPC, MIC, or PIC on page 255
•
Installing an MX240 AC Normal-Capacity Power Supply on page 256
•
Installing an MX240 DC Normal Capacity Power Supply on page 258
•
Installing an MX240 SCB on page 261
Installing the MX240 Craft Interface
To install the craft interface (see Figure 88 on page 230):
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Grasp the craft interface with one hand, and hold the bottom edge of the craft interface
with the other hand to support its weight.
3. Orient the ribbon cable so that it plugs into the connector socket. The connector is
keyed and can be inserted only one way.
229Copyright © 2017, Juniper Networks, Inc.