Juniper MX240 - Installing an MX240 as MXC; Figure 102: Installing an as MSC

Figure 102: Installing an AS MSC
g006674
Related
Documentation
MX240 Application Services Modular Storage Card Description on page 86•
• Replacing an MX240 AS MSC on page 328
• Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
Installing an MX240 AS MXC
To install an AS MXC (see Figure 103 on page 253):
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Align the notches in the connector at the rear of the AS MXC with the notches in the
AS MXC slot (slot 1—the bottom slot in the AS MLC), and then slide the AS MXC in
until it lodges firmly in the AS MLC.
CAUTION: Slide the AS MXC straight into the slot to avoid damaging the
components on the bottom of the AS MXC.
3. Use one of the following methods to bring the AS MXC online:
Copyright © 2017, Juniper Networks, Inc.252
MX240 3D Universal Edge Router Hardware Guide