Figure 114: Removing the Fan Tray
Installing the MX240 Normal-Capacity Fan Tray
To install the fan tray (see Figure 90 on page 232):
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Grasp the fan tray handle, and insert it straight into the chassis. Note the correct
orientation by the this side up label on the top surface of the fan tray.
3. Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
Copyright © 2017, Juniper Networks, Inc.272
MX240 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
