Juniper MX240 - Installing the MX240 Normal-Capacity Fan Tray; Figure 89: Installing the Air Filter

Figure 89: Installing the Air Filter
Related
Documentation
Maintaining the MX240 Air Filter on page 378•
• Removing the MX240 Air Filter on page 269
• Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
Installing the MX240 Normal-Capacity Fan Tray
To install the fan tray (see Figure 90 on page 232):
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2. Grasp the fan tray handle, and insert it straight into the chassis. Note the correct
orientation by the this side up label on the top surface of the fan tray.
3. Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
231Copyright © 2017, Juniper Networks, Inc.
Chapter 21: Installing Components