5. Align the bracket with the two mounting holes located toward the top center of the
chassis.
There is no mounting hole in the center of the chassis that corresponds to the hole in
the center of the bracket.
6. Insert the two screws at the top of the bracket and tighten each partially.
Two screws are needed for mounting the bracket on the center of the chassis. You
do not need the third screw.
7. Tighten the two screws completely.
8. Repeat the procedure for the other bracket.
Related
Documentation
• Installing the MX240 Router Mounting Hardware for a Rack or Cabinet on page 167
• Installing the MX240 Router By Using a Mechanical Lift on page 177
• Installing the MX240 Chassis in the Rack Manually on page 189
Copyright © 2017, Juniper Networks, Inc.170
MX240 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
