Observe the status LEDs on the power supply faceplate. If the power supply is correctly
installed and functioning normally, the PWR OK, BRKR ON, and INPUT OK LEDs light
green steadily.
Related
Documentation
• Disconnecting an MX240 DC Power Supply Cable on page 343
• DC Power Cable Specifications for the MX240 Router on page 160
• DC Power Disconnection Warning for M Series, MX Series, and T Series Routers
• DC Power Wiring Sequence Warning for M Series, MX Series, and T Series Routers
• DC Power Wiring Terminations Warning for M Series, MX Series, and T Series Routers
• MX240 DC Power Electrical Safety Guidelines
209Copyright © 2017, Juniper Networks, Inc.
Chapter 17: Connecting the MX240 Router to Power
To Next Page
