4. Insert the other end of the cable into the destination port.
5. Repeat the previous steps for any additional cables.
6. If the component is offline (its failure indicator LED is lit), use one of the following
methods to bring the PIC online:
•
To bring a DPC or an MPC online:
•
Press and hold the corresponding online button on the craft interface until the
green OK LED next to the button lights steadily, in about 5 seconds.
•
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see the CLI Explorer.
•
To bring a PIC online:
•
Press the PIC offline/online button until the PIC LED lights green. For a PIC installed
in FPC3, use a narrow-ended tool that fits inside the opening that leads to the
button.
•
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the CLI Explorer.
•
To bring a MIC online:
•
Press the MIC offline/online button until the PIC LED lights green.
•
Issue the following CLI command:
user@host>request chassis mic fpc-slot mpc-slot pic-slot mic-slot online
For more information about the command, see the CLI Explorer.
The normal functioning indicator LED confirms that the component is online. You can
also verify correct DPC or MPC functioning by issuing the show chassis fpc command
or correct MIC or PIC functioning by issuing the show chassis fpc pic-status.
Related
Documentation
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444•
• Maintaining MX240 PICs on page 395
• Troubleshooting the MX240 PICs on page 410
• MX240 PIC Serial Number Label on page 427
• MX240 PIC Description on page 59
• Replacing an MX240 FPC on page 302
Copyright © 2017, Juniper Networks, Inc.322
MX240 3D Universal Edge Router Hardware Guide
To Next Page
Loading...
