12 Appendix
12.3I-O function and KCM state indications
Page 100 Docu-No.: 1090020601-EN Rev. 1.2.1
DISA, start command is required. If the state is “WAIT”, a start
command is not required.
• On power-up, KCM is Stopped. A Start Command is always
required.
• If the host communications is reading the CondensedProcStatus,
the KCM state can be determined from the following bits in the
status word. Assuming the word starts at bit 0, bits 2 and 3 would
help identify the state.
To Next Page
Loading...
