K-TRON KCM - Common Drive I-O; SFT Connections for All Drives

12 Appendix
12.5Summary of KCM I-O
Page 124 Docu-No.: 1090020601-EN Rev. 1.2.1
12.5.2 Common Drive I-O
These connections are common to all drive types. See later specific
sections for other drive connections.
12.5.3 SFT Connections for all drives
# J1-Digital Inputs J3-Int Channel,
PS
J5-Relays
1 +24 Vdc +24 Vdc to KCM Relay 1 Com
2 Safety Input Common Relay 1 NO
3 24 Vdc power TxD+ RS485 Relay 1 NC
4 Drive Ena + TxD- RS485 Relay 2 Com
5 Drive Ena - RxD+ RS485 Relay 2 NO
6 Common RxD- RS485 Relay 2 NC
7 24 Vdc power Relay 3 Com
8 MDU In 1 Signal Relay 3 NO
9Common
10 24 Vdc power
11 MDU In 2 Signal
12 Common
• Only J4 is used on the 450 watt DC drive
• Not for PID or VOL applications
# J4/J7/J8 SFT
1 +12 Vdc @ 100mA
2Common
3 TxD+ RS485
4 TxD- RS485
5RxD+ RS485
6RxD- RS485