1 Safety Notes
1.7 Safety devices
Page 12 Docu-No.: 1090020601-EN Rev. 1.2.1
1.7 Safety devices
1.8 High voltage
1.9 Additional equipment
1.10 Customer service and repairs
▲ Never open or remove covers or hoods while the equipment is in
operation.
▲ Do not modify the electrical safety devices, for example fuses.
Increased risk of accident.
▲ Replace damaged cables and connections immediately.
▲ Switch off the power to the equipment. Do not open the enclosure
in an explosive atmosphere. Before accessing internal
components, allow 3 minutes to lapse prior to opening the
enclosure. This ensures safe discharge of high voltage
components.
▲ Only qualified electricians may work on the electrical equipment of
the equipment.
▲ High voltage may be present on the line power cables of the
device.
▲ Switch off the power to the device for 3 minutes before:
– any disassembly, maintenance and repair work
– replacing the drive
▲ Protect the device against moisture entrance.
▲ Modifications to the equipment are prohibited.
▲ The operator is responsible for complying with all safety
regulations related to interoperation with any additional
equipment.
▲ Have repairs to the equipment carried out by
– your authorized K-Tron customer service center
or
– qualified personnel, trained by K-Tron.
▲ Only use original K-Tron parts for repairs.
▲ In EX equipment may only manufacturer-approved batteries used.
Replacement from the battery, see section 9.4.
To Next Page
Loading...
