Charging status of the DC link:
- 5: phase failure => DC voltage lower than required for oper-
ation
- 2: charging => Load-shunt-delay time is running
- 4: run => Operation (modulation release) possi-
ble
Voltage in DC link [0.1V]
Peak value of the DC voltage
is deleted by Power-On or overwritten with the value 0
Motor apparent current [0.01A]
display apparent
current PT1
Smoothing time for the motor current display in ru10
Peak value of unsmoothed motor apparent current
Deletion by Power-On or overwriting with 0
Ratio of the actual motor current to short time current limit
[0.1%]
Mean effective motor load [0.1%]
Reference torque (output of the speed controller)
1000 =
100%
dr09 rated
torque
Actual torque (COMBIVIS display in %)
Actual torque (COMBIVIS display unnormalized)
Smoothing time for the torque display in ru23 / ru24 /
ru81
Torque limits, which result from the settings in cs12 …
cs16 or in the profile parameters 0x60E0 / 0x60E1.
The final limits can be different due to the influence of
the limiting characteristic or the operation mode (e.g.
fault reaction ramp).
1000 =
100%
dr09 rated
torque
To Next Page
Loading...
Need help?
General
