KEB specific parameters and standard - conform parameters
Displays the error state of the CANopen client
General error (is set with all other error messages)
Error overpotential or underpotential
A value of 0 (no bit set) means: No error
9.3.2.2.5 Speed displays
For the following object there is no KEB specific object in the same resolution:
Actual speed for speed control (as ru08) but with the reso-
lution 1 = 1rpm (resolution of the velocity modes)
Parameter conform to other fieldbus system standards
Other fieldbus systems which are supported on KEB devices of type F6 and S6 are
VARAN on control type K and PROFINET, POWERLINK and EtherNetIP on control type
A.
Information on these fieldbus systems and the associated parameters can be found in the
Programming Manual | Fieldbus systems .
The Programming manual | Fieldbus systems can be downloaded from the KEB website.
Registration is required.
To Next Page
Loading...
Need help?
General
